Parts Name Of Remote Controller - Toshiba RAS-M10GDCV-E Manuel Du Propriétaire

PARTS NAME OF REMOTE CONTROLLER

a START/STOP button
Push the button to start operation.
(A receiving beep is heard.)
Push the button again to stop operation.
(A receiving beep is heard.)
If no receiving sound is heard from the indoor unit, push
the button twice.
b Mode select button (MODE)
Push this button to select a mode.
Each time you push the button, a mode is selected in a
sequence that goes from A : Auto changeover control,
: Cool, : Dry,
: Fan only (For Cooling only model), and back to A.
(A receiving beep is heard.)
c Temperature button
... The set temperature is increased up to 30°C.
... The set temperature is decreased to 17°C.
(A receiving beep is heard.)
d Fan speed button (FAN)
Push this button to select fan speed. When you select
AUTO, the fan speed is automatically adjusted according to
the room temperature.
You can also manually select the desired fan speed among
five settings.
+
(LOW , LOW
HIGH ) (A receiving beep is heard.)
e Off timer button (OFF)
Push this button to set the OFF timer.
f On timer button (ON)
Push this button to set the ON timer.
g Reserve button (SET)
Push this button to reserve time settings.
(A receiving beep is heard.)
h Cancel button (CLR)
Push this button to cancel ON timer and OFF timer.
(A receiving beep is heard.)
i High power button (Hi-POWER)
Push this button to start the high power operation.
j Memory button (MEMO)
Push this button to stand by memorizing the settings.
Push the button again for more than 4 seconds to
memorize the setting indicated on the remote controller
and mark is indicated.
(Refer to "MEMORY/PRESET OPERATION")
k ECO timer button (ECO)
Push this button to start the ECO timer (OFF timer)
operation.
You can select the OFF timer time among four settings (1,
3, 5 or 9 hours).
l PRESET button
Push this button to operate the air conditioner according to
settings memorized by the MEMO button.
m TIMER button
Use this button to change the clock, ON timer, and OFF
timer times.
To forward the time, push the "TIMER
To set back the time, push the "TIMER
n Automatic operation button (AUTO)
Push this button to operate the air conditioner
automatically. (A receiving beep is heard.)
(Refer to "AUTOMATIC OPERATION")
EN
: Heat (for Heat pump model only),
+
, MED , MED ,
" button.
" button.
CAUTION
• When pushing the "SWING", "FIX" and "FILTER" buttons
Indoor unit does not operate and the receiving beep sound
also not appear.
6