Preparation And Check Before Use - Toshiba RAS-M10GDCV-E Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29

PREPARATION AND CHECK BEFORE USE

Loading the remote controller batteries.
a Remove the cover, and insert the batteries.
b Push the RESET button.
The clock display flashes.
Adjust the clock.
Place back the cover.
Removing the batteries
a Remove the cover, and take out the
batteries.
b Reattach the cover.
* Please dispose of the batteries according
to the local regulation.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep from the indoor unit or when the air conditioner cannot be operated using the
remote controller.
• To avoid malfunctions by battery leakage, remove the batteries when not using the remote controller for more than one month.
Setting the clock
Before you start operating the air conditioner, set the clock of the remote controller using the procedures given in this section.
The clock panel on the remote controller will indicate the time regardless of whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock panel will indicate
AM 0:00 and will flash.
a TIMER
button
Push the TIMER
button to set the current time.
Each push of the TIMER button changes the time in one minute steps.
Pushing the TIMER button continually changes the time in ten minute steps.
b SET
button
Push the SET
button.
The current time is indicated and the clock starts.
Clock adjusting
a CLOCK button
Push the CLOCK button.
The CLOCK display flashes.
b TIMER
button
Push the TIMER
button to set the current time.
Each push of the TIMER button changes the time by one
minute.
Pushing the TIMER button continually changes the time by
ten minutes.
c SET
button
Push the SET
button.
The current time is indicated and the clock starts.
EN
• Slide off the cover while
pushing the sides.
• Battery replacement
Be careful not to reverse
the (+) position and the
(–) position.
Push CLOCK
8

Publicité

Table des Matières
loading

Table des Matières