Temporary Operation/Voltage Setting - Toshiba RAS-M10GDCV-E Manuel Du Propriétaire

TEMPORARY OPERATION/VOLTAGE SETTING

TEMPORARY switch (COOL, AUTO)
When you can't use the remote controller temporarily due to missing, etc., temporary operation can be performed on the switch panel.
• Setting the TEMPORARY switch to "AUTO" starts the automatic operation, to "COOL" starts the cooling operation (fan speed: LOW),
respectively.
To stop the temporary operation, set the switch to "AUTO RESTART OFF".
Voltage setting
The most suitable voltage can be set up by combining the VOLTAGE SELECT 1 with 2 when adjusting the voltage on the spot.
(Do not touch the switches at the installation time because an installation dealer will adjust them.)
Supply voltage Voltage select 1/Voltage select 2
220V
230V
240V
5
(Both are available.)
EN