Reely ROAD P-190 Notice D'emploi page 65

Chassis
Model pulls to one side
Model can only be controlled with
difficulty
Brake is inactive
Clutch does not engage
Clutch does not disengage
Model does not run
Damping not soft and smooth-
running
Shock absorbers are losing oil
Model overturns backwards when
accelerating
Steer trimming not set correctly
Track on the left and right not identical
Wheel on one side broken or broken bearing
Servo linkage is not adjusted correctly
Received power of aerial too low
Batteries of transmitter and/or receiver discharged
Brake linkage misadjusted
Brake disc worn out
Clutch shoe worn out or broken
Clutch bell worn out or broken
Flywheel has come loose
Springs of clutch shoes worn out or broken
Main pinion defective
Broken pinions in the differentials
Centrifugal clutch adjusted too loosely
One or more shock absorbers are jammed
Piston rod bent
A damping component is defective
Gaskets are worn out
Centrifugal clutch adjusted too tightly
Correct neutral position on the remote control
Set the track back to 0° for both sides
Take off the wheel, clean the bearing and, if necessary, replace it
Put servos in neutral position and re-adjust them
Completely extend the transmitter aerial, completely unroll the
receiver aerial and lay it upwards
Replace batteries or recharge rechargeable batteries
Readjust the brake linkage lever
Replace the brake disc
Replace the clutch shoes
Replace the clutch bell
Retighten the flywheel attachment
Replace the springs
Replace the main pinion
Replace the pinions
Re-adjust the centrifugal clutch
Clean and/or take apart the shock absorber
Repair the piston rod
Check and replace the defective part
Replace the gaskets
Loosen the adjustment screw until the model starts smoothly
65