Reely ROAD P-190 Notice D'emploi page 48

Installation of receiver and antenna
After the function control and the mounting of the servos, the receiver,
the ON/OFF switch, the battery holder and the antenna can be
permanently inserted in the receiver box on the chassis.
• Screw off the cover with the name of the switch position of the ON/
OFF switch.
• Guide the ON/OFF switch from the inside through the opening in the
lid of the receiver box.
• Put the cover back onto the switch from the outside and fasten the
cover through the lid with the switch.
• Make sure that the marking of the cover "ON" or "OFF" of the switch
state corresponds with the actual switch state, meaning that the power
supply is turned on at "ON" and off at "OFF".
• Connect the connectors of the switch cable with the battery holder of
the receiver.
• Insert 4 batteries or rechargeable batteries type Mignon/AA in the
battery/rechargeable battery box (alternatively a 6 V hump rechargeable
battery pack) and place it horizontally at the back of the receiver box.
• Connect the servos with the receiver.
• When laying the cables make sure that they are as taut as possible
and that they can't get into contact with rotating parts. To fix the cables
use cable binders. Tuck excess lengths into receiver box.
• Turning the receiver upright onto its narrow side, it fits in the front of
the receiver box.
• Guide the antenna wire of the receiver from the inside through the
boring in the lid of the box and afterwards through the antenna guidance
tube.
• Insert the antenna guidance tube in the holder on the outside of the lid
and secure the antenna wire on the top on the guidance tube by
wrapping adhesive tape around it or by pulling a piece of stocking tube
over it.
• Make sure that the lid for changing the rechargeable batteries can still
be opened easily after fixing the antenna wires (don't pull wire out too
far).
• Never shorten the antenna cable of the receiver, try not to bind it
together! This reduces the range.
48