Operation - Husqvarna LB 146 Manuel D'utilisation

To assemble the handle
WARNING:
battery.
1. Install the upper handle to the lower handle and
tighten the knobs (A), washers (B) and screws (C)
fully on the right and left sides. (Fig. 19)
CAUTION:
are not caught or become damaged.
2. Fold the handle up. (Fig. 20)
3. Put the stay in the groove on the cutting cover. (Fig.
21)
4. Attach the 2 stops that lock the stay and the handle.
Push them fully in position. (Fig. 22)
Note:
There are 2 stops, 1 identified with an H and
1 with a V. Put the stop with an H on the right side
and the stop with a V on the left side.
CAUTION:
product if the 2 stops are not attached.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
10
For LB 246E, remove the
Make sure that the wires
Do not operate the

Operation

Before you operate the
To adjust the handle height
1. Remove the handle stay from the lower handle. (Fig.
23)
a) Put the handle stay in the top hole (A) to
decrease the handle height.
b) Put the handle stay in the bottom hole (B) to
increase the handle height. (Fig. 24)
To set the product in transport position
1. Loosen the knobs. (Fig. 25)
2. Release the stay. (Fig. 26)
3. Fold the lower handle and the stay forward. (Fig. 27)
4. Fold the upper handle rearward.
To set the product in operation position
1. Fold the upper handle forward.
2. Fold the lower handle rearward in a upright position.
(Fig. 28)
3. Put the stay in the groove. (Fig. 29)
4. Fold the upper handle up.
5. Tighten the knobs fully.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. Refer to
examine the cutting equipment on page 12 .
3. Do a check of the oil level and fill with engine oil if it
is necessary. Refer to
on page 13 .
4. Fill the fuel tank. Refer to
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
To
To do a check of the oil level
To fill fuel on page 10 .
Do not use gasoline with an
287 - 008 - 22.10.2021