8: Connecting The Ac Power Cord - Sony HT-K25 Mode D'emploi

Installing the control center
on the wall
Attach the jack cover. Fasten the screws (not
supplied) to the wall at the same height 80 mm
apart. The screws should protrude by 5 to
6 mm.
5 to 6 mm
Remove the seals covering the hanging holed.
Hang the control center on the screws. Push the
control center tightly against the wall.
80 mm
4.2 mm
9.2 mm
Notes
• Use the screws that matches the wall material and
strength.
• Install the control center on a vertical and flat wall
where reinforcement is applied. Do not instal the
control center if the wall is not vertical, flat or
strong enough.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• After the control center has been used for long time
on the wall, the wall behind or above the control
center may discolor or peel off by radiation of heat
from the control center depending on the wall
material.
• Sony will refrain from any responsibility on the
accident or damage caused by improper installation,
lack of durability of the wall or screws improper
operation, natural calamity, etc.
• When you disconnect or connect the cords, take the
control center down from the wall.
8: Connecting the AC
power cord
After connecting the components, connect the
AC power cord of the subwoofer to a wall
outlet.
AC power cord
b
To a wall outlet
Subwoofer
CONTROL
GB
13