7: Attaching The Jack Cover And Stand - Sony HT-K25 Mode D'emploi

To avoid short-circuiting the
speakers
Short-circuiting may damage the speakers and
cause a malfunction.
Make sure the stripped ends of each
speaker cord does not touch the
stripped end of another speaker cord.
Examples of poor conditions of the
speaker cord
Stabilizing speakers
To prevent speaker vibration or movement
while listening, attach the supplied foot pads at
the bottom of the speakers. If you are using the
speaker stand (not supplied), you do not need
to attach them.
Using speaker stand (not supplied)
When using separately sold speaker stand
(WS-FV10C, WS-TV10C, WS-WV10C), you
can easily configure your speaker layout.
WS-FV10C
WS-WV10C
(Wall use)
WS-TV10C
7: Attaching the jack
cover and stand
You can use the control center laid flat, or in an
upright position by attaching the supplied stand
to the rear or side of the control center. You
can also install the control center on the wall.
Besides, you can change the item layout in the
display according to the layout of the control
center (page 16).
Attaching the jack cover
1
Gather all the connecting cords
together.
2
Attach the jack cover carefully so as
not to pinch the cords. Then fix the jack
cover with the supplied screws using
the hexagonal wrench.
Notes
• Make sure that the connecting cords are not trapped
by the jack cover.
• If you use commercially available cords, it is
recommended that you use cords similar in size to
the cords provided with this system. If the cords are
too thick or stiff, or the plug is too large, you may
not be able to attach the jack cover securely. If you
cannot attach the jack cover, you do not have to
attach the jack cover.
continued
GB
11