Chain Counter Setting Menu; Measurement Menu - Navimo Lofrans Galaxy503 Manuel D'installation Et D'utilisation

5 MENU

5.2 Chain counter setting menu

Hold down the (ON) key for six seconds to
access the instrument setting menu. The following
page will appear on the display:
Use the (DOWN) and (UP) keys to
move around the menu options.
Once you are positioned on the item to be modified press the
Use the (DOWN) or (UP) keys to move from one parameter to another.
Once one is positioned on the parameter press the
According to the type of parameter, using the
reduce/increase the value of the same or disable/enable the function.
Once the modification has been performed, press the
Using the (DOWN) key go to the Exit option and press the
setting menu. The same procedure must be used to return to the main page.
Menu
M e a s u r e
A l a r m s & F u n c t i o n
S e t t i n g s
L a n g u a g e
S e n s o r C a l i b r a t i o n
(ON) key to confirm your choice.
(ON) key to enable modification.
(DOWN) and (UP) keys it is possible to
(ON) key to confirm.
(ON) key again to return to the

5.3 Measurement menu

Measure
R e s e t M e a s u r e
U n i t s
R o p e _ C h a i n
E x i t
Use the (DOWN) or (UP) key to move around the parameters.
Reset Measurement
Resets the chain measurement value (0.0).
Units
Selects the unit of measurement:
Feet/ inches
Metres / centimetres
Rope_Chain
It is possible to enable the function and set
the value at which the sensor passes from
rope to chain. Setting range 0.1 - 25.0
(metres or feet). This value corresponds to
the chain length.
To obtain this function, install sensor
CMCT-01 (optional).
Exit
To return to the settings menu.
Contametri mod. Galaxy 503/703
N o
F e e t
O f f
Select with
= Yes = No
Confirm with
Select with
= Feet = Metres
Confirm with
Select with
Set value with
Confirm with
Confirm with
19