Safety Information; Items Supplied - EINHELL GH-BC 33-4 S Mode D'emploi D'origine

Anleitung_GH_BC_33_4_S_SPK7__ 13.05.13 15:44 Seite 20
GB
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety information with due care. Keep these
operating instructions in a safe place so that the
information is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and the safety information as
well. We cannot accept any liability for damage or
accidents which arise due to a failure to follow these
instructions and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety information.
CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety information
and instructions set out below may result in an electric
shock, fire and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
Safety devices
When working with the equipment, the appropriate
plastic guard hood for cutting blade mode or cutting
line mode must be fitted to prevent objects being
thrown out by the equipment. The integrated blade in
the cutting line guard hood automatically cuts the line
to the optimum length.
2. Layout (Fig. 1-14)
1. Connecting piece for long handle
2. Long handle
3. Steady grip
4. Starter cable
5. Choke lever
6. Petrol tank
7. Fuel pump "primer"
8. Ai r filter housing cover
9. On/Off switch
10. Throttle lever lock
11. Throttle lever
12. Throttle lock
13. Line spool with cutting line
14. Cutting line guard hood
15. Cutting blade guard hood
16. Cotter pin (2x)
17. Carrying strap
20
18. Cutting blade
19. Holder for steady grip
20. Handle screw M8
21. Protective cap
22. Carrier plate
23. Pressure plate
24. Pressure plate cover
25. Nut M10 (left-hand thread)
26. Filling bottle
27. Spark plug wrench
28. Open-ended spanner 8/10 mm
29. Allen key size 4 mm
30. Allen key size 5 mm
31. Screwdriver
32. Cable tie (2x)
33. Support plate
34. Screw (2x)
35. Air filter
36. Spark plug boot
37. Handle screw M6
38. Oil filler screw

3. Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts.
There is a danger of swallowing or suffocating!
Petrol power scythe
n
Long handle
n
Steady grip
n
Holder for steady grip
n
Cotter pin (2x)
n
Carrying strap
n
Handle screw M8
n
Handle screw M6
n
Cutting blade
n
Line spool with cutting line
n
Carrier plate
n
Pressure plate
n
Pressure plate cover
n
Nut M10 (left-hand thread)
n