Adjusting The Picture - Sony DSC-1024G Mode D'emploi

Adjusting the picture

S
ON/OFF
While watching the picture, you can adjust contrast, phase,
chroma and aperture to suit your taste. The adjustments can
be carried out for the three inputs separately. The adjusted
levels are stored in memory.
Adjusting the contrast, phase, and chroma
Press the desired adjustment button: CONTRAST, PHASE,
or CHROMA.
The adjustment levels are displayed on the screen.
CONTRAST
CONTRAST
+: to increase picture contrast
–: to decrease picture contrast
PHASE
PHASE
+: to make overall picture greenish
–: to make overall picture purplish
CHROMA
CHROMA
+: to increase color intensity
–: to decrease color intensity
Notes
• CHROMA and PHASE controls do not function for the RGB
input signal.
• PHASE control does not function for the component (Y/B-
Y/R-Y) input signal.
• PHASE control does not function with PAL color source.
If you press these buttons, "NOT APPLICABLE" appears on
the screen.
36
TV
IN NTSC PAL
PJ
OFF
OUT NTSC PAL
COMMAND DISPLAY TEST LINE OUTPUT
ON/OFF FORMAT
MODE PATTERN DOUBLER GEN-LOCK
MENU
CENT
ENTER
80
CONTRAST
0
PHASE
50
CHROMA
OVERFLOW indicator
OVER FLOW
SIGNAL FORMAT
31.5k 37k 48k 64k OTHERS
31.5k 37k 48k 64k
APERTURE
CHROMA PHASE CONTRAST
SIZE
CHROMA button
PHASE button
CONTRAST button
Adjusting the aperture
To make the picture sharper, press the APERTURE button to
set APERTURE on the screen to ON. The indicator of the
APERTURE button lights.
To make the picture softer, press the APERTURE button again
to set APERTURE to OFF.
The factory setting is APERTURE OFF for the NTSC or PAL
video input, or APERTURE ON for the other inputs.
APERTURE
Note
When the output signal format is an interlaced signal such as
NTSC and PAL, setting APERTURE OFF reduces line flickers
although the image contour becomes slightly blurred.
If the input signal level is excessive
The OVERFLOW indicator lights. In this case, check that the
75 /OPEN selector and the RGB/YBR selector in the VIDEO
3 connector section are set correctly. If they are correct, press
the CONTRAST – button.
Restoring the factory preset contrast, phase and
chroma levels
Use COLOR RESET on the MENU 1 screen. (See page 39.)
OPEN SCAN CONVERTER DSC-1024G
INPUT SELECT
STILL
1 2 3
ZOOM
APERTURE button
APERTURE zON OFF