Rear Panel - Sony DSC-1024G Mode D'emploi

Rear panel

1
Y/C
IN OUT
COMP
REF
IN OUT
VIDEO 1 IN
1 VIDEO 1 IN connector section
2 VIDEO 2 IN connector section
Two sets of video inputs and loop-through outputs.
Y/C IN (4-pin):
Connect to the Y/C output of video equipment.
This connector has a priority over the COMP IN connector,
if both connectors are used.
COMP IN/REF (BNC type):
Connect to the composite video output of video
equipment.
Also, input the reference signal for the gen-lock (black
burst signal) to the VIDEO 1 IN REF connector.
Y/C OUT (4-pin):
Loop-through output of the Y/C IN connector.
COMP OUT (BNC type):
Loop-through output of the COMP IN connector.
3 VIDEO 3 IN connector section
A set of RGB or component (Y/B-Y/R-Y) signal inputs.
RGB/component input (D-sub 15-pin, 3-row):
Connect one of the D-sub connectors to the RGB outputs of
video equipment or the component (Y/B-Y/R-Y) outputs
of a Betacam SP video cassette recorder. The other D-sub
connector is a loop-through output.
Termination switch:
When nothing is connected to the loop-through output
connector, set to 75 . When the loop-through output
connector is used, set to OPEN.
RGB/YBR* selector:
Select the position to match the format of the signal input
to the D-sub connector.
SYNC selector:
Normally set to AUTO. Set to ON G to use the sync signal
on green channel when both external sync signal and sync
on green signal are input.
* YBR is an abbreviation of Y/B-Y/R-Y component signal.
2 3
THROUGH
Y/C
75 OPEN
IN OUT
RGB YBR
COMP
SYNC
AUTO ON G
IN OUT
VIDEO 2 IN VIDEO 3 IN
4 5
L L L
RGB YBR
SEP COMP
R R R
SYNC
AUDIO 1 AUDIO 2 AUDIO 3
VIDEO OUT AUDIO IN
4 VIDEO OUT connector section
Three sets of video outputs. The converted signal is
output from this section.
Y/C output (4-pin):
Connect to the Y/C input of video equipment.
Only the NTSC or PAL signal is output from this
connector.
Composite video output (BNC type):
Connect to the composite video input of video equipment.
Only the NTSC or PAL signal is output from this
connector.
RGB/component output (D-sub 15-pin, 3-row):
Connect to the RGB or component (Y/B-Y/R-Y) inputs of
video equipment.
RGB/YBR output selector:
Set this selector depending on the format of the signal
output from the D-sub connector. YBR is effective when the
NTSC or PAL signal is output.
SYNC output selector:
Select the sync signal for the RGB output.
Set to SEP to use separate horizontal/vertical sync signal.
Set to COMP to use the composite sync signal.
5 AUDIO IN L/R jacks (RCA pin)
Three sets of audio inputs.
Connect to the audio output jacks of equipment. If the
input source is monaural, connect it to the L jack only.
You can select the audio input with the INPUT SELECT
buttons on the front panel.
6 AUDIO OUT L/R jacks (RCA pin)
A set of audio outputs.
Connect to the audio input jacks of equipment.
7 CTRL S IN/OUT jacks (minijack)
Connect to the CONTROL S jacks of other Sony equipment.
It is then possible to control the whole system with a single
remote commander.
When a plug is connected to the CTRL S IN jack, the
remote sensor on the front panel becomes inactive.
8 AC IN connector
Connect the supplied power cord.
6 7 8
L IN
OUT
R
AC IN
OUT CTRL S
31