Hookup For Getting The Down-Converted Signal - Sony DSC-1024G Mode D'emploi

Hookup for getting the down-converted signal

The following diagram shows a connection example to convert a high-rate input signal into a low-rate output signal.
Personal computer,
workstation, etc.
Y/C
IN OUT
COMP
REF
IN OUT
VIDEO 1 IN
VIDEO 3 IN selectors
VIDEO IN (composite)
Setting the VIDEO OUT selectors
• Set the RGB/YBR selector to RGB when a video monitor or
video projector is connected.
Set it to YBR when a Betacam SP video cassette recorder is
connected.
• Set the SYNC selector to SEP (HD or VD separate sync) or
COMP (composite sync) depending on the connected
equipment.
Computer
monitor
R/G/B IN
AUDIO OUT
R/G/B OUT
VIDEO 3 IN
(loop-through)
VIDEO 3 IN
THROUGH
Y/C
OPEN
75
IN OUT
RGB YBR
COMP
SYNC
AUTO ON G
IN OUT
VIDEO 2 IN VIDEO 3 IN
VIDEO
OUT (BNC)
or
or
Video monitor
To watch the original picture output from the
computer or workstation with the monitor, connect
the monitor cable that has been removed from the
computer or workstation to VIDEO 3 IN loop-through
output.
VIDEO OUT selectors
L L L
RGB YBR
SEP COMP
R R R
SYNC
AUDIO 1 AUDIO 2 AUDIO 3
VIDEO OUT AUDIO IN
VIDEO OUT
(D-sub 15-pin)
Signal cable (supplied)
R/G/B/HD/VD IN or
Y/R-Y/B-Y IN
Betacam SP video cassette
recorder, etc.
When the computer monitor is connected to the
VIDEO 3 IN loop-through output
Set the VIDEO 3 IN selectors as follows:
• 75
/OPEN selector m OPEN
• RGB/YBR selector m RGB
• SYNC selector m AUTO or ON G depending on the
connecting equipment
For Macintosh and Silicon Graphics Inc. computers, set to
ON G.
Audio cable
(if necessary)
AUDIO IN
AUDIO 3 L/R
IN
L
R OUT
AC IN
OUT CTRL S
OUT L/R
AC IN
AC power cord
to a wall outlet
AUDIO IN
L/R
33