Hookups; Hookup For Getting The Up-Converted Signal - Sony DSC-1024G Mode D'emploi

Hookups

Before you get started
• First make sure that the power to each piece of equipment is
turned off.
• Use connecting cables suitable for the equipment to be
connected.
• The cable connectors should be fully inserted into the jacks.
A loose connection may cause hum and other noise.

Hookup for getting the up-converted signal

The following diagram shows a connection example to convert a low-rate input signal into a high-rate output signal.
VCR, laser disc player,
game machine, etc.
S VIDEO
OUT
VIDEO 1 IN
Y/C IN
Y/C
IN OUT
COMP
REF
IN OUT
VIDEO 1 IN
VIDEO 3 IN selectors
Computer monitor (VGA or SVGA),
etc.
Setting the VIDEO OUT selectors
• Set the RGB/YBR selector to RGB (when a computer
monitor, data projector or LCD projector is connected).
• Set the SYNC selector to SEP (HD or VD separate sync) or
COMP (composite sync) depending on the connected
equipment.
32
AUDIO CONTROL
S OUT
OUT L/R
VIDEO OUT selectors
VIDEO 3 IN
THROUGH
Y/C
OPEN
75
IN OUT
RGB YBR
COMP
SYNC
AUTO ON G
IN OUT
VIDEO 2 IN VIDEO 3 IN
R/G/B/HD/VD IN
Data projector, LCD projector,
etc.
• To disconnect the cable, pull out by grasping the plug.
Never pull the cable itself.
• Read the instruction manual of the equipment to be
connected.
Betacam SP video cassette
recorder
COMPONENT
(Y, R-Y, B-Y)
AUDIO IN
AUDIO 1 L/R
L L L
RGB YBR
SEP COMP
R R R
SYNC
AUDIO 1 AUDIO 2 AUDIO 3
VIDEO OUT AUDIO IN
VIDEO OUT
Signal cable (supplied)
When the Betacam SP video cassette recorder is
connected to VIDEO 3 IN
Set the VIDEO 3 IN selectors as follows:
• 75
/OPEN selector m 75
• RGB/YBR selector m YBR
• SYNC selector m AUTO
Connect only the three plugs of the signal cable to the Betacam
SP video cassette recorder: green plug to Y connector, red to R-
Y, and blue to B-Y. Leave the other plugs, if provided,
disconnected.
AUDIO OUT L/R
AUDIO IN
AUDIO 3
L/R
CTRL S IN
IN
L
OUT
R
AC IN
OUT CTRL S
OUT L/R
AC IN
AC power cord
to a wall outlet
AUDIO IN
L/R
Public announcement
system, etc