Dometic FreshJet 3000 Instructions De Montage page 19

FreshJet3000
I
NOTE
Additional duct sections can be purchased for thicker roofs.
➤ Attach the required number of duct sections on the ADB.
➤ Fasten the ADB to the ceiling through to the roof air conditioner with the
4 bolts supplied.
See fig. h, page 8
A
NOTICE! Risk of damage
Tighten to the specified torque. Do not overtighten!
➤ Tighten the screws using a torque spanner and a fastening torque of
2.5 Nm ±0.3 Nm.
8.5.5 Communication cable
➤ Connect the communication 4 pin plug into the socket on the side of the
display (2) in the ADB.
➤ Ensure the cable is located into the small opening away from the filter area.
➤ Secure excess cable into the holders.
➤ Push the filter back fully in.
See fig. i, page 8
➤ Clip the centre cover to the ADB.
The installation is now completed. Connect to the power and test.
EN
Installation
19