Multifunction Display Service Screens - Nilfisk Advance SW5500 Instructions D'utilisation

ENGLISH

MULTIFUNCTION DISPLAY SERVICE SCREENS

Main screen (E, Fig. 3)
1. Turn the ignition key (51) to the starting position "I" while
holding down push-buttons (52) and (53) to access the
main screen (E, Fig. 3).
2. Press push-button (A) to change the machine settings (see
the Machine Settings Screen paragraph).
3. Press push-button (B) to check any alarms stored by the
machine (see the Alarms Memory Screen paragraph).
4. Press push-button (C) to check the machine working hours
(see the Hour Counter Screen paragraph).
5. Press push-button (D) to exit super user mode and return
to operator mode.
Machine Settings Screen (F, Fig. 4)
This function allows you to customize the value of the
parameters described in the following table of modifiable
parameters.
1. To increase the value of the current parameter, press
push-button (C).
To decrease the value of the current parameter, press
push-button (D).
2. To move to the next parameter, press push-button (A).
3. To return to the main screen, hold down push-button (B).
TABLE OF MODIFIABLE PARAMETERS
Code Description
VSL Side broom speed
SCF
Filter shaker activation time
FVMIN Minimum forward speed
FVMAX Maximum forward speed
RVMAX Maximum reverse speed
BAT Installed battery type (see table)
TOFF Automatic shut-off time
BRGH
Display contrast
RESET Resets all parameters to the factory default values
Installed Battery type
WET Battery with liquid acid electrolyte
GEL / AGM Generic GEL or AGM batteries
22
INSTRUCTIONS FOR USE
SW5500 - 1467284000
E
Figure 3
F
Figure 4
Values
Minimum Factory Setting
50% 100%
5 sec 20 sec
0% 25%
10% 85%
10% 30%
0 0
0 sec 300 sec
5 25
0 0
Value
0
1
A
B
C
D
P100897
A
B
C
D
P100898
Maximum
100%
60 sec.
100%
100%
50%
1
600 sec
50
1
09/2016