Parking Brake; Machine Operation - Nilfisk Advance SW5500 Instructions D'utilisation

ENGLISH

PARKING BRAKE

1. Engage the parking brake by pressing the pedal (6) and engaging the lever (7).
2. Disengage the parking brake by pressing and releasing the pedal (6).
WARNING!
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Engage the parking brake when parking the machine on a slope.
WARNING!
Before leaving the machine unattained, be sure that the parking brake can stop the machine with a large safety
margin.
WARNING!
When using the machine on slopes, respect the maximum gradient values marked on the machine itself (see
technical characteristics table).

MACHINE OPERATION

1. Drive the machine to the work area as shown in the previous paragraph.
2. Start cleaning by lowering the main broom and activating the vacuum system with the One-Touch push-button (52).
3. (Optional) activate the DustGuard™ system with the corresponding push-button (68).
4. Lower the side brooms with the push-buttons (53) and (54, optional). If necessary, adjust the speed of the side brooms with the
+ and - push-buttons (55, icon on display 71-I).
NOTE
The brooms (18, 15 and 16) can be lowered and lifted even when the machine is moving.
When the brooms are lowered, the brooms, the vacuum system and the dust guard system (optional) automatically
activate only when the machine is moving.
NOTE
The side broom icons (71-F) keep the operator informed of the working configuration of the side brooms. When the icon
is present, the corresponding side broom is activated and deactivated together with the main broom via the One-Touch
push-button (52).
5. Start sweeping by driving the machine with the hands on the steering wheel (1) and by pressing the accelerator pedal (5). If
necessary, set the maximum speed with the push-buttons (58) and (59).
6. Drive the machine straight forward at a quick walking speed. Drive the machine slower when sweeping large amounts of dust
or debris or when safe operation dictates slower speeds. Overlap passes 10 cm.
7. To collect light and bulky waste materials, lift the front skirt by pressing the pedal (8); take into consideration that the machine
vacuum capability is reduced when the front skirt is lifted.
WARNING!
When operating on wet floors, it is essential to turn off the vacuum system by pressing the push-button (56) to
prevent the dust filter from being damaged.
8. For machine proper operation, the dust filter must be as clean as possible. To clean it while sweeping, operate the filter shaker
by pressing the push-button (57).
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
This procedure can also be performed when the machine is moving.
CAUTION!
When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris any more.
9. The hopper (12) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph).
CAUTION!
In the event of an overload of one of the broom motors, due to foreign bodies blocking it or excessive pressure
of the broom on the ground (see procedure in the Main/Side Broom Height Check and Adjustment paragraph of
the Maintenance chapter), a safety system stops the motor.
The machine must be switched off and on again to restart work after a stop due to an overload.
16
INSTRUCTIONS FOR USE
SW5500 - 1467284000
09/2016