Brake Pedal; Drive Pedal - GGP ITALY MP 84C Manuel D'utilisation

Mechanical transmission
4.21 CLUTCH / BRAKE PEDAL
This pedal has two functions: during
the first part of its travel it acts as a
clutch, engaging and disengaging
drive to the wheels, and in the sec-
ond part it acts as a brake on the
rear wheels.
IMPORTANT
Do not keep
the pedal halfway between clutch engagement or disen-
gagement, as this can cause overheating and damage the
transmission belt.
NOTE
When the machine is moving, keep
your foot off the pedal.
4.22 SPEED CHANGE LEVER
This lever has seven positions for
the 5 forward speeds, the neutral
position «N», and reverse «R».
To go from one speed to another,
press the pedal (4.21) halfway and
shift the lever as shown on the la-
bel.
WARNING!
Only shift into reverse when the
machine has stopped moving.
4.21
4.22
Hydrostatic transmission

4.31 BRAKE PEDAL

This pedal works the brake on the
rear wheels.

4.32 DRIVE PEDAL

This pedal engages drive in the
wheels and controls the machine's
forward and reverse speeds.
– To engage forward drive, press it
towards «F» with your toe-cap.
As you increase the pressure on
the pedal, the speed of the ma-
chine increases.
– Reverse is engaged by pressing
the pedal with the heel towards «R».
– The pedal automatically goes into neutral «N» when re-
leased.
WARNING!
Only shift into reverse when the
machine has stopped moving.
NOTE
If the drive pedal is used, whether
forwards or for reverse, the engine stops as soon as the
parking brake (4.4) is engaged.
4.31
4.32
EN 15