End Of Work; Cleaning The Machine - GGP ITALY MP 84C Manuel D'utilisation

– shift into neutral (N) ( 4.22
Mechanical transmission
or 4.32 Hydrostatic trans-
mission) and stop moving
forward;
– engage the parking brake on
slopes;
– pull out the lever (1- if fitted)
or grasp the rear handle (1a)
and tip up the grass-catcher
to empty it;
– close the grass-catcher so
that it hooks onto the pawl
(2).
5.4.7 Unblocking the collector channel
Cutting very tall or wet grass, particularly at excessively high
speed, can clog up the collector channel. If this happens pro-
ceed as follows:
– stop moving forward, disengage the blades and stop the en-
gine;
– remove the grass-catcher or stone-guard;
– remove the grass cuttings; you can reach them from the exit of
the collector channel.
WARNING!
This job must only be performed with
the engine turned off.
5.4.8 End of mowing
When you have finished mowing, disengage the blades, lower
the engine speed and ride the machine with the cutting deck
raised as high as possible.
1a
1
2

5.4.9 End of work

Stop the machine, move the throttle to «SLOW» and turn off the
engine by turning the key to «OFF».
WARNING!
To avoid
backfire, position the throttle on
«SLOW» for 20 seconds before
stopping the engine.
When the engine has stopped, close
the fuel stopcock (1) (if fitted).
WARNING!
Always take out the ignition key be-
fore leaving the machine unattended!
IMPORTANT
To keep the battery charged, do not leave
the key in the «ON» position or «HEADLIGHTS ON» when the
engine is not running.

5.4.10 Cleaning the machine

After each mowing, clean the outside of the machine, empty the
grass-catcher and shake it to remove residual grass and earth.
WARNING!
Always empty the grass-catcher and
do not leave containers full of cut grass inside a room.
Clean the plastic parts of the body with a damp sponge using
water and detergent, taking care not to wet the engine, the elec-
trical parts or the electronic circuit board located under the dash-
board.
1
EN 23