Tractel Minifor TR125 SY Instructions D'emploi Et D'entretien page 33

Never:
- Use the equipment described in this
manual to lift or carry persons.
- Use the hoist if it has not been inspected
over the past year.
- Suspend the hoist to a structure not
having sufficient strength.
- Secure the hoist by any other means
than its specific anchoring device.
- Raise or lower a load without having a
complete view of the entire path.
- Use the hoist for any operation other than
those for which it is intended, or follow any
other assembly diagrams other than
those described in this manual.
- Use the hoist with loads exceeding its
working load limit.
- Anchor the hoist by its carrying handle.
- Use the hoist without first making sure that
the high and low limit stops are in place.
- Attempt to lift loads which are fixed or
blocked.
- Apply lateral traction on the load.
- Connect the hoist to a connector without
first making sure of the power outlet's
compatibility with the hoist and for
presence of the regulatory electrical safety
devices on the power outlet circuits.
- Reeve the hoist.
- Use idler pulleys with the Minifor™
synthetic rope.
- Pull a load along the ground.
- Apply a load or force, particularly a
traction, on the slack section of the
synthetic rope.
- Use the hoist seated on its base without
correctly wedging it to a sufficiently strong
host structure.
- Allow the load to swing under the hoist.
- Take position or move around under the
load.
- Place your hand or any other part of your
body near the synthetic rope passage or
drive mechanism openings.
- Block the hoist in a fixed position or
prevent it from self-aligning with the load.
- Use the hoist without first having checked
correct operation of all its safety
equipment.
- Use the hoist for any application other
than vertical lifting of material loads.
- Use the Minifor™ synthetic rope as a
slinging device.
- Use any other synthetic rope other than
the Minifor™ synthetic rope.
- Allow a tensioned synthetic rope or a
load to rub against or snag on an
obstacle.
- Expose the Minifor™ synthetic rope to
chemical substances containing acids.
- Use the hoist with a damaged minifor™
synthetic rope.
- Touch the cooling fins while the motor is
turning.
- Use the hoist in an explosive environment
(hoist not compliant with ATEX directive).
- Use the hoist or its synthetic rope when
the temperature is less than –10°C or
greater than +50°C.
- Use the hoist when the wind speed is
greater than 50 km/h.
- Press the control buttons haphazardly
repeatedly, or too quickly.
- Maneuver the hoist by its electric power
cable.
- Perform any modification not described
in this manual.
- Use a high-pressure cleaner or chemical
products (acids, chlorinated products)
to clean the hoist.
33
GB