Noise Emission Values; Before Putting The Machine Into Operation - CMi C-BS 250 Manuel D'utilisation

466957.book Seite 58 Donnerstag, 9. Dezember 2010 7:14 07

Noise emission values

Blade length:
GB
Max. blade width:
Blade speed:
Cutting height:
Throat:
Table size:
Tilting range of table:
Workpiece size:
Weight:
Noise emission values
Sound pressure level L
Shakiness K
PA
Sound power level L
Shakiness K
WA
Wear ear protection.
Noise can result in hearing loss.
Restrict the noise development and vibration to minimum!
• Use only correct devices.
• Maintain and clean the device regularly.
• Adjust your working methods with the device.
• Do not overload the product.
• The device can be checked if required.
• Switch the device off, if not in use.
Load factor:
A load factor of S2 15 min (intermittent periodic duty) means that you may operate the motor con-
tinuously at its nominal power level (250 W) for no longer than the time stipulated on the specifica-
tions label (15 minutes ON period). If you fail to observe this time limit the motor will overheat. Dur-
ing the OFF period the motor will cool again to its starting temperature.

6. Before putting the machine into operation

• Make sure the machine stands securely, i.e. bolt it to a workbench or solid base. There are two
holes for this purpose in the machine foot.
• The saw table must be mounted correctly.
• All covers and safety devices have to be properly fitted before the machine is switched on.
58
PA
WA
466957 V_01/12/2010
1400 mm
8 mm
900 m/min
80 mm / 90°
45 mm / 45°
200 mm
300 × 300 mm
0° – 45°
400 × 400 mm
20 kg
Cutting
82.3 dB (A)
3 dB
92.8 dB (A)
3 dB