Residual Risks; Technical Data - CMi C-BS 250 Manuel D'utilisation

466957.book Seite 57 Donnerstag, 9. Dezember 2010 7:14 07
39. Observe the national relevant prevention regulations.
40. Position the blade guard so it is approx. 3 mm above the material you want to saw.
41. Important! Support long workpieces (e.g. with a roller table) to prevent them sagging at the end
of a cut.
42. Make sure the blade guard (10) is in its lower position when the saw is being transported.
43. Safety guards are not to be used to move or misuse the machine.
44. Blades that are misshapen or damaged in any way must not be used.
45. If the table insert is worn, replace it.
46. Never operate the machine if either the door protecting the blade or the detachable safety
device are open.
47. Ensure that the choice of blade and the selected speed are suitable for the material to be cut.
48. Do not begin cleaning the blade until it has come to a complete standstill.
49. In the case of straight sawing against the parallel stop, a push stick must be used.
50. The bandsaw blade guard should be in its lowest position close to the bench during transport.
51. For miter cuts when the table is tilted, the parallel stop must be positioned on the lower part of
the table.
52. When cutting round timber, use a suitable holding device to prevent the workpiece turning.
53. Never use guards to lift or transport items.
54. Ensure that the bandsaw blade guards are used and correctly adjusted.
55. Keep your hands a safety distance away from the bandsaw blade. Use a push stick for narrow
cuts.

Residual risks

Even if these electrical tools are operated properly, residual risks always remain. Following dangers
may appear in conjunction with type and design of this electrical tool:
1. Lung injuries, if no suitable dust mask is worn.
2. Hearing disabilities, if no suitable hearing protection is worn.
Pull the power plug before beginning
any repair or maintenance work!
Wear safety goggles
Wear ear-muffs
Wear a breathing mask

5. Technical data

Voltage:
Power:
Ideal speed no:
230 V~ / 50 Hz
S1 180 W / S2 15 min 250 W
1400 min
466957 V_01/12/2010
5. Technical data
-1
57
GB