Saeco GranAroma SM6585 Mode D'emploi page 21

Problem
The milk is splashing.
The machine seems to
be leaking.
Cause
The type of milk used is not
suitable for frothing.
The milk you use is not cold
enough.
The flexible milk tube is not
connected properly.
The cappuccinatore and milk
tubes are not clean.
The milk tubes are clogged.
The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
Solution
Different types of milk result in different
amounts of froth and different froth
qualities.
Make sure you use cold milk coming
directly from the fridge.
Open the door of the coffee dispensing
spout (Fig. 47) and check if the flexible
milk tube is fully connected to the
cappuccinatore (Fig. 53). Note that the
cappuccinatore and milk tubes may be
hot. Let the cappuccinatore and the
tubes cool down before you touch
them.
Remove and disassemble the internal
cappuccinatore (see 'Cleaning the
internal cappuccinatore under the tap').
Rinse all parts under the tap. For
thorough cleaning, use Philips milk
circuit cleaner and perform the Deep
Milk Clean procedure via the cleaning
( ) menu. Note that if the parts have
been cleaned in the dishwasher, they
may have become clogged by food
particles or detergent residues. A visual
check that they are not obstructed is
also recommended.
We advise you to perform the
HygieSteam program every day: 1) Press
'Clean' on the control panel. 2) Select
'HygieSteam'. 3) Press the start button
to start the process. Then confirm all
steps on the display.
Always store the milk container without
the milk tubes in the refrigerator.
Leftover milk could accumulate inside
the milk tubes and block the flow of
milk through the tubes. Rinse the milk
tubes before storage.
Empty the drip tray every day or as
soon as the 'drip tray full' indicator pops
up through the drip tray cover. Tip:
Place a cup under the dispensing spout
to collect rinsing water and reduce the
amount of water in the drip tray.
Empty the drip tray every day or as
soon as the 'drip tray full' indicator pops
up through the drip tray cover.
English
21