Removing And Inserting The Brew Group; Reinserting The Brew Group; Cleaning And Maintenance - Saeco GranAroma SM6585 Mode D'emploi

10 Hot water will be dispensed from the spout during 1 minute.
11 The filter is now successfully activated.
Replacing the AquaClean water filter (5 min.)
After 95 liters of water have flowed through the filter, the filter will cease to work. The AquaClean
status indicator drops to 0% to remind you to replace the filter. As long as the AquaClean status
indicator is shown on the display, you can replace the filter without having to descale the machine
first. If you do not replace the AquaClean water filter in time, the AquaClean indicator goes out after
some time. In that case you can still replace the filter but you first need to descale the machine.
When the AquaClean status indicator drops to 0% or when the machine reminds you to replace the
AquaClean filter:
1 take out the old AquaClean water filter.
2 install a new filter and activate it as described in chapter 'Activating the AquaClean water filter (5
min.)'.
Replace the AquaClean water filter at least every 3 months, even if the machine does not yet
indicate that replacement is required.

Removing and inserting the brew group

Go to www.saeco.com/care for detailed video instructions on how to remove, insert and clean the
brew group.
Removing the brew group from the machine
1 Switch off the machine.
2 Remove the water tank and open the service door (Fig. 26).
3 Press the PUSH handle (Fig. 27) and pull at the grip of the brew group to remove it from the
machine (Fig. 28).
When you remove the brew group from the machine, make sure to empty the drip tray and the
coffee grounds container.

Reinserting the brew group

Before you slide the brew group back into the machine, make sure it is in the correct position.
1 Check if the brew group is in the correct position. The arrow on the yellow cylinder on the side of
the brew group has to be aligned with the black arrow and N (Fig. 29).
-
If they are not aligned, push down the lever until it is in contact with the base of the brew group
(Fig. 30).
2 Slide the brew group back into the machine along the guiding rails on the sides (Fig. 31) until it locks
into position with a click (Fig. 32). Do not press the PUSH button.
3 Close the service door and place back the water tank.

Cleaning and maintenance

Regular cleaning and maintenance keeps your machine in top condition and ensures good-tasting
coffee for a long time with a steady coffee flow.
English
13