Operating The Device Safely - Dometic Waeco Bordbar CDF-11 Notice D'emploi

_CDF-11.book Seite 19 Freitag, 24. September 2010 1:57 13
BordBar CDF-11
The cooling device is not suitable for transporting caustic mate-
rials or materials containing solvents.
Do not open the refrigerant circuit under any circumstances!
Connect the device with the 12/24 V lead supplied to a 12/24 V
e
socket.
Do not pull the plug out of the cigarette lighter or the socket by
the cable.
If the connection cable is damaged, it must be replaced with the
cable of the same type and specifications.
Pull out the connection cable:
– Before cleaning and maintenance
– After use
On boats: if the device is powered by the mains, ensure that the
power supply has a ground fault interrupter circuit. Danger of
fatal injuries!
Disconnect the cooling device and other power consuming de-
vices from the battery before connecting the quick charging de-
vice.
Check that the voltage specification on the type plate corre-
sponds to that of the energy supply.
1.2

Operating the device safely

Before starting the device, ensure that the power supply cable
a
and the plug are dry.
Do not place the device near naked flames or other heat sourc-
es (heaters, direct sunlight, gas ovens etc.)
Caution! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other ob-
jects so that the air can circulate.
Do not fill the inner container with ice or fluid.
Never immerse the device in water.
Protect the device and the cable against heat and moisture.
Safety instructions
19