Using The Emergency Switch; Switching Off The Cooler; Defrosting The Cooler - Dometic Waeco Bordbar CDF-11 Notice D'emploi

_CDF-11.book Seite 27 Freitag, 24. September 2010 1:57 13
BordBar CDF-11
5.10

Using the emergency switch

The device is equipped with an emergency switch. Thus you can keep cool-
ing if an error occurs within the interior electronics.
Note
I
During normal operation the emergency switch (fig. 1 12, page 2)
has to be set to the "Normal" position.
➤ If the interior electronics fail: Slide the emergency switch to the "Emergen-
cy" position.
5.11

Switching off the cooler

➤ Empty the cooler.
➤ Switch the cooler off: Press the "ON/OFF" button (fig. 2 1, page 2) for
three seconds.
➤ Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤ Leave the cover slightly open. This prevents odour build-up.
5.12

Defrosting the cooler

Humidity can form frost in the interior of the cooling device or on the vaporis-
er. This reduces the cooling capacity. Defrost the device in good time to avoid
this.
Caution!
a
Danger of damaging the device!
Never use hard or pointed tools to remove ice or to loosen objects
which have frozen in place.
To defrost the cooler, proceed as follows:
➤ Take out the contents of the cooling device.
➤ If necessary, place them in another cooling device to keep them cool.
➤ Switch off the device.
➤ Leave the cover open.
➤ Wipe off the defrosted water.
Operation
27