Cleaning; Blockage Of Defrost Water Drain Tube; Spare Parts; Servicing - Gram K 200 Mode D'emploi

1. Switch off power at the mains socket. Dismount the top panel pos.A and
disconnect the multiplug inside.
2. Remove the hinge pin pos. B, and lift off the door.
3. Move hinge pos. D to pos. E.
4. Move the handle from pos. F, to pos. G.
5. Place the door at the hinge in pos. E. Mount the hinge pin pos. B in hinge pos. C
and in the door hinge bush. Fasten the hinge.
6. Connect the multiplug inside the panel pos. A, and fasten the panel. Apply power
to the cabinet again.

Cleaning

Before cleaning, switch off the cabinet at the mains.
The cabinet should be kept clean using a mild soap solution. Do not use cleaning detergents
that may cause scratches. The plastic parts cannot withstand boiling water (max.
temperature +85°C).
When regular cleaning is carried out, be sure to wipe clean the rubber door gasket to ensure
any sticky substances are removed which would otherwise damage the gasket.
The condenser fan air outlet above the compressor must be free of leaves, paper etc. to
ensure normal operation of the cabinet.
The condenser on the back of the cabinet must be regularly cleaned as well. This is best
done with a vacuum cleaner and a brush.

Blockage of defrost water drain tube

Blockage sometimes occurs in the plastic elbow at the defrost water outlet.
Remove the blockage in the best way possible and then for safety's sake clean the elbow
itself with a bent pipe cleaner.

Spare parts

When ordering spare parts that you can easily fit yourself, please give the cabinet type
number and the function of the part(s) concerned.

Servicing

The hermetically sealed refrigerating system requires no inspection - just maintenance.
If the system fails and you cannot find the cause, contact a refrigeration repair service.
76-504-0940
17