Charging The Battery Pack - Kenwood TK-D240 Guide De L'utilisateur

CHARGING THE BATTERY PACK

ATTENTION:
◆ Always switch OFF a transceiver equipped with a battery pack before
inserting the transceiver into the charger.
1 Plug the AC adapter cable into the jack located on the rear of
the charger.
2 Plug the AC adapter into an AC outlet.
3 Slide a battery pack or a transceiver equipped with a battery
pack into the charging slot of the charger.
• Make sure the metal contacts of the battery pack mate securely
with the charger terminals.
• The indicator lights red and charging begins.
4 When charging is completed, the indicator lights green.
Remove the battery pack or the transceiver from the charging
slot of the charger.
• It takes approximately 3 hours to charge the battery pack.
• When the charger will not be used for a long time, unplug the AC
adapter from the AC outlet.
Note:
◆ When the indicator blinks red, the battery pack is either defective or
the battery pack contacts are not properly mated with those of the
charger.
◆ When the indicator fl ashes green and orange, the battery pack has
not satisfi ed the charging start temperature. Remove the battery
pack from the charger and wait until it reaches a normal temperature
before charging it again.
◆ The ambient temperature should be between 41°F and 104°F (5°C
and 40°C) while charging is in progress. Charging outside this range
may not fully charge the battery.
12
Indicator