Charging The Battery Pack - Kenwood NEXEDGE Série Mode D'emploi

CHARGING THE BATTERY PACK

The battery pack is not charged at the factory; charge it before
use.
ATTENTION: Always switch OFF a transceiver equipped with a
battery pack before inserting the transceiver into the charger.
1 Plug the AC adapter cable into the jack located on the rear
of the charger.
2 Plug the AC adapter into an AC outlet.
3 KSC-43 Only: Match the holder to the type of battery pack
to be charged so that when inserting the holder, the battery
type name can be seen on the bottom of the charger. After
inserting the holder into the charger, press the locking tabs
to secure it in place.
• To remove the holder, squeeze the locking tabs together then
pull the holder out of the charger.
4 Slide a battery pack or a transceiver equipped with a
battery pack into the charging slot of the charger.
• Make sure the metal contacts of the battery pack mate
securely with the charger terminals.
• The indicator lights red and charging begins.
Indicator
4
Holder
Li-ion battery
charger
Indicator
Ni-MH battery
charger