Selecting A Zone And Channel - Kenwood NEXEDGE Série Mode D'emploi

SELECTING A ZONE AND CHANNEL

1 Select the desired zone using the key programmed as
[Zone Up] or [Zone Down].
• Each zone contains a group of channels.
2 Select the desired channel using the Channel selector.
• Each channel is programmed with settings for transmitting and
receiving.
TRANSMITTING
1 Select the desired zone and channel.
2 Press the key programmed as [Monitor] or [Squelch Off]
to check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone.
Release the PTT switch to receive.
• For best sound quality, hold the transceiver approximately
1.5 inches (3 ~ 4 cm) from your mouth.
RECEIVING
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to "SIGNALING"
on page 17 for details.
12