Controls; Icons - Jacobsen Sand Scorpion Manuel De L'opérateur Et De Sécurité

3

CONTROLS

3 CONTROLS
3.1

ICONS ___________________________________________________________________

Read Manual
Light Switch
Choke Coolant Temp.
Never attempt to drive the tractor unless you have read the Operator's Manual and know
how to operate all controls correctly.
Familiarize yourself with the icons shown above and what they represent. Learn the
location and purpose of all the controls and gauges before operating this tractor
3.2 CONTROLS _______________________________________________________________
A. Parking Brake
The parking brake is located just above the brake
pedal. To set parking brake, hold brake pedal down
and press parking brake until it locks in place. To
disengage, press brake pedal down and then
release.
Note: The parking brake will release automatically
when the accelerator pedal is pressed. However,
releasing the brake by pressing it is the preferred
method. This method ensures the longest service life
of the brake.
B. Service Brake
To slow or stop machine remove foot from forward/
reverse pedals and press brake pedal down.
GB-8
Engine Oil
Pressure
Hourmeter Fuel
Gas
Lower
!
Engine Speed
High Low
Diesel Parking
Scarifier
Raise Lower
!
WARNING
C. Forward Pedal
Press pedal down for forward travel. Release pedal
to slow tractor and stop. The forward pedal can also
be used for reverse travel by pulling up under pedal.
D. Reverse Pedal
Press pedal down with heel for reverse travel.
Release pedal to stop.
!
Note: The operator can choose to have the rear
pedal removed. Remove pedal from main linkage
under floor panel. With pedal removed, reverse travel
is controlled by pulling up using your toe under front
pedal.
Ignition Switch
Glow Plug Off
Brake Traction Foot Pedals
Service Forward
Rake
Raise
CAUTION:
Allow Tractor to come to a com-
plete stop before reversing direction.
Run Start
Reverse