Controls - Jacobsen G-Plex III Manuel De L'opérateur Et De Sécurité

6

CONTROLS

GB
6.1 HAND CONTROLS - DIESEL
1. Voltmeter
2. Hour Meter
3. Headlight Switch
4. Engine Oil Warning Light
5. Ignition Switch
6. Throttle
8. Pre–Heat Switch and Glow Plug Light
9. Temperature Gauge And Warning Light
10. Reel Enable Switch
Voltmeter
indicates battery condition.
Headlight Switch
turns the headlights on and off.
Engine Oil Warning Light
will come on when the engine oil pressure is too low
for operation.
Ignition Switch
has four positions:
OFF - prevents all electrical functions from
operating. Switch must be in the OFF position to
remove the key.
ON - for normal operation.
START - engages the starter. Release the key after
engine starts (the switch automatically returns to
ON).
ACC. - has no function on this unit.
NOTE
If the engine fails to start, or if it "dies" for any
reason, the ignition switch must be returned to
the OFF position before restarting is attempted.
This feature prevents damage to the starter and
flywheel teeth that can occur if the starter is
engaged while the engine is running. Wait 30
seconds before restarting engine.
WARNING
!
When the ignition is switched on, if the
units are in the lowered position they will
raise. It should be ensured that
operators/bystanders are clear of all
moving parts before the ignition switch is
switched on.
All manuals and user guides at all-guides.com
!
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL
Throttle
Push all the way forward for normal engine operating
speed, and all the way back for idle.
Hour Meter
records the number of hours the engine has run. Use
the hour meter to manage a good scheduled
maintenance program (refer to the Maintenance
Guide).
Temperature Gauge and Warning Light
gauge indicates coolant temperature and light warns
of overheat situation.
Reel Enable Switch
This switch must be in the on position (1) in order for
the reels to rotate. The switch must be in the off
position (0) for the unit to be started.
Preheat Switch & Glow Plug Light
With the ignition switch in the 'ON' position, hold the
preheat switch in the 'ON' position until the indicator
lamp go's out. The engine can now be started.
GB-11