Jacobsen Sand Scorpion Manuel De L'opérateur Et De Sécurité page 10

3 CONTROLS
I. Hood Latches
Release latches before lifting hood. Keep latches
fastened while operating tractor.
J. Tilt Steering
Press lever down to release steering column. The
steering column has three positions. Tilt column up
or down to position desired. Release lever to lock
steering column in place.
K. Scarifier Lever (optional)
Push forward to lower attachment, pull back to raise
attachment.
L. Light Switch
Turns front headlight on and off. Operates only with
the ignition switch in the RUN position.
M. Throttle Lever
Regulates engine speed. Push lever forward to
increase speed. Pull lever back to decrease engine
speed.
N. Rake Lever
Push forward to lower rake, pull back to raise rake.
NOTE: Never operate in reverse with rake down.
Rake may fold under tractor and damage rake and
tractor.
O. Ignition Switch
The Ignition Switch has three positions OFF, RUN
and START. To prevent unauthorized operation,
remove the ignition key when the tractor is not in use.
To start tractor, read and follow start-up procedures
in Sections 4.3 & 4.4.
P. Engine Oil Light
The red light will come on if engine oil pressure drops
below a safe level. Stop engine immediately,
determine the cause and correct problem.
Q. Voltmeter
Monitors the condition of the electrical system.
During normal operation, voltmeter needle should
never be in the red area.
R. Hour Meter
Records the operating hours of the tractor. Use the
hour meter to schedule maintenance intervals. The
meter operates only when the ignition key is in the on
position.
GB-10
S. Choke (Gasoline Engines)
Pull choke out to start a cold engine. Push choke in
as engine warms up.
T. Circuit Breaker (20 Amp)
A 20 amp pop-up type circuit breaker protects the run
circuit. To reset breaker push button down.
CAUTION:
!
quently could indicate a possible electrical
problem. Have electrical system checked by a
trained mechanic.
U. Circuit Breaker (50 Amp- Diesel Engines)
A 50 amp pop-up type circuit breaker protects the
start circuit. To reset the breaker push button down.
V. Glow Plug Switch (Diesel Engines)
Use to energize the glow plugs and preheat the
engine cylinders to improve cold weather starts.
W. Water temperature Gauge
Indicates engine coolant temperatures. Normal
operating temperature should be between 85° -
91°C.
K N
L
M
T S
Gasoline
A circuit breaker that opens fre-
K N
L
O
T
U
P
M
Q
R
Q
R
Diesel
Figure 3B
O
V
W
P
TRG001