Exterior Surfaces; Range Hood Care; Cleaning - KitchenAid LI3ZBE Instructions D'installation Et Guide D'utilisation Et D'entretien

IMPORTANT: Clean the range hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating range hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water or all-purpose cleanser.
■
Wipe with damp soft cloth or nonabrasive sponge, then rinse
■
with clean water and wipe dry.
Metal Grease Filter
To Remove Metal Grease Filters:
1. Use two hands to remove the metal grease filters. Grasp
filter handles, push toward the rear of the range hood and
pull down on the front handle to remove.
2. Repeat for each grease filter.
3. Wash metal grease filters as needed in a dishwasher or hand
wash in a hot detergent solution to clean.
To Reinstall Metal Grease Filters:
1. Grasp filter handles and place rear of filter into rear track.
2. Push down on the rear handle and set the front of the grease
filter into the front track to secure.
3. Repeat for each filter.

RANGE HOOD CARE

Cleaning

This range hood uses two 175-watt maximum heat lamps. Turn
off the heat lamps and allow them to cool.
To Replace:
1. Disconnect power.
2. Remove the heat lamp bulb from its socket.
3. Replace the heat lamp bulb with the same type bulb and
4. Repeat steps 2 and 3 with the other heat lamp bulb if
5. Reconnect the power.
Turn off the range hood and allow the halogen lamp to cool.
To avoid damage or decreasing the life of the new bulb, do
not touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120-volt, 50-watt
4. Repeat steps 2-3 for the other bulb if needed.
5. Reconnect power.
Replacing a Heat Lamp
tighten it in its socket.
necessary.
Replacing a Halogen Lamp
maximum halogen bulb with a GU10 base. Turn it clockwise
to lock it into place.
17