IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions� Replace grease filters
before operating hood�
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads�
Always wipe dry to avoid water marks�
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser�
■
Wipe with damp soft cloth or nonabrasive sponge, then rinse
■
with clean water and wipe dry�
Metal Grease Filter
To Remove Metal Grease Filters:
1. Use two hands to remove the metal grease filters� Grasp
filter handles, push toward the rear of the range hood, and
pull down on the front handle to remove�
2. Repeat for each grease filter�
3. Wash metal grease filters as needed in a dishwasher or hand
wash in a hot detergent solution to clean�
To Reinstall Metal Grease Filters:
1. Grasp filter handles and place rear of filter into rear track�
2. Push down on the rear handle and set the front of the grease
filter into the front track to secure�
3. Repeat for each filter�
12
RANGE HOOD CARE
Cleaning
Turn off the range hood and allow the halogen lamp to cool� To
avoid damage or decreasing the life of the new lamp, do not
touch lamp with bare fingers� Replace lamp, using tissue or
wearing cotton gloves to handle lamp�
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service�
1. Disconnect power�
2. Push up on the lens and turn it counterclockwise�
3. Remove the lamp and replace it with a 120-volt, 50-watt
4. Repeat steps 2-3 for the other lamp if needed�
5. Reconnect power�
Replacing a Halogen Lamp
maximum halogen lamp with a GU10 base� Turn it clockwise
to lock it into place�