Features - Ryobi RYi2200GR Manuel D'utilisation

Masquer les pouces Voir aussi pour RYi2200GR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRODUCT SPECIFICATIONS
ENGINE
Engine Type ............................. 80cc Overhead Valve (OHV)
Spark Plug .............................. NGK BPR7HS or equivalent
Engine Lubricant Volume........................................13.52 oz
Fuel Volume................................................................. 1.2 gal.
*Rated output determined by PGMA Standard G300
KNOW YOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
120 V AC RECEPTACLES
Your generator has two single phase, 60 Hz outlets that are
120 Volt AC, 20 Amp receptacles. These can be used for
operating appropriate appliances, electrical lighting, tools,
and motor loads.
AIR FILTER
The air filter help to limit the amount of dirt and dust drawn
into the unit during operation.
AUTO IDLE SWITCH
The auto idle switch is used to control the speed of the
engine and conserve fuel. When Auto Idle is on and no
appliances are connected to the unit, the engine will idle.
If an appliance is added, the engine speed will increase to
power the item. If the appliance is removed, the engine will
return to idle.
CARRY HANDLES
The generator is equipped with two carry handles for
easy transport. Both handles should be used to carry the
generator.
EASY START DIAL
The Easy Start dial is used when starting, stopping, and run-
ning the engine. It also controls the choke and the fuel valve.
FUEL TANK
The fuel tank has a capacity of 1.2 gallon.
GROUND TERMINAL
The ground terminal is used to assist in properly grounding
the generator to help protect against electrical shock. Con-
sult with a qualified local electrician for grounding require-
ments in your area.

FEATURES

GENERATOR
Rated Voltage ........................................................ 120V AC
Rated Amps ........................................................ 14.16A AC
Rated Output*......................................................... 1,700 W
Starting Watts ......................................................... 2,200 W
Rated Frequency ........................................................ 60 Hz
LED DISPLAY
LED provides feedback to indicate whether the generator
is overloaded.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
lubricant in the crankcase is insufficient. The engine may
not be restarted until sufficient engine lubricant has been
added to the generator.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
PARALLEL KIT TERMINALS
The non-polarized parallel kit terminals are used with a
parallel kit (sold separately) that will allow generators to be
linked together to increase output.
NOTICE:
Do not connect or disconnect cables while the generator
is running. The generator or the load may be damaged.
NOTE: Read and understand the parallel kit's instructions
prior to use. Kit is for usage with this unit only.
RECOIL STARTER
The recoil starter is used (along with the Easy Start dial) to
start the generator's engine.
RESET BUTTON
The reset button is used to restore power if an overload
occurs. To restore power, depress the reset button.
RETRACTABLE HANDLE
The generator is equipped with a retractable handle that can
be adjusted for storage and transportation.
10 — English

Publicité

Table des Matières
loading

Table des Matières