Use Of A Bedpan Or Bucket; Charging Batteries - lopital Reflex 5100 5600 Mode D'emploi

3.7.2. Use of a bedpan or bucket

• If the Reflex is being used as a toilet chair, the special
guides under the seat can be used to accommodate a
stainless steel / plastic bedpan or bucket .
• The bedpan or bucket is slid in from the back of the chair
(See figure 22) .
• If you are using the Lopital plastic bedpan, you must slide it
as far forwards as possible (See figure 23) .
• If you are using a stainless steel bedpan or bucket, the
bedpan can be placed in 2 positions under the seat . At the
front of the seat (See figure 24) of aan de achterkant van
de zitting (See figure 25) .
In order to avoid injuries, we advise the carer to
remove the lid from the seat and insert the bucket or
bedpan before the client takes a seat on the chair.
The Lopital plastic bedpan, stainless steel bedpan and
bucket must be cleaned and disinfected after use, for
example in a bedpan washing unit.
If the Lopital plastic bedpan, stainless steel bedpan or
bucket has been used, it must be removed from the
chair before the chair is moved or adjusted in height.

3.8. Charging batteries

• The Reflex is an electrically driven high / low shower-toilet
chair and works on batteries .
• The charging point is located on the back of the chair (1)
(See figure 26) .
• If the batteries are almost completely empty, the LED (2)
next to the battery symbol on the control panel will blink
red to indicate that the batteries must be charged
(See figure 26) .
• Connect the charger to the Reflex (See figure 26) .
• Open the metal flap (1) and connect the charger to the
Reflex (See figure 26) .
40 | Instructions for use | Reflex Shower-toilet chair
Figure 22 Bedpan .
Figure 23 Lopital plastic
bedpan .
Figure 24 Stainless steel
bedpan, front .
Figure 25 Stainless steel
bedpan, back .