lopital Reflex 5100 5600 Mode D'emploi page 35

• The carer or the client first raises one leg; the carer then folds the foot plate down
(See figure 5). The same procedure is then carried out with the other leg . Make sure
that the footrest is set to the right height .
• The footrest height is adjustable in steps over 23 cm / 9 inch (Minimum 26 .5 cm /
10 .4 inch and maximum 50 cm / 19 . 7 inch, measured from the top of the seat to the
upper side of the foot plates) .
Always replace this component on the chair when you have finished using it.
This will avoid the component being lost.
Footrest on Reflex with Flexo footrest (Article number chair: 5100 5605).
Figure 6 Folding up foot plates .
• Before the client takes a seat in the Reflex, the foot plates must be folded upwards .
This will ensure there is sufficient space for the person to easily take a seat in the chair
(See figure 6). If more room is required, the Flexo foot rests can be turned out (See
figure 7) . First, the foot rests must be slightly raised (1) and then they can be turned
outwards (2) .
• The carer or the client first raises one leg; the carer then folds the foot plate down
(See figure 8) . The same procedure is then carried out with the other leg .
Always replace this component on the chair when you have finished using it.
This will avoid the component being lost.
1
Figure 7 Turning out footrests .
Reflex Shower-toilet chair | Instructions for use | 35
2
Figure 8 Folding down foot plates .