Operation; Wheel Blocking; Footrest - lopital Reflex 5100 5600 Mode D'emploi

Step 10
Take the chair off the brake when you wish to move it
(See paragraph 3.1. Wheel blocking) Always move the chair in the low position.
Step 11
When you wish to tilt the chair or move it upwards / downwards, you must apply the
brake (See paragraph 3.5 Moving upwards / downwards and paragraph 3.6. Tilting) .

3. Operation

3.1. Wheel blocking

• The brake can be applied on the Reflex by pushing the blue
lip (1) on the wheel downwards (See figure 2).
• In order to take the Reflex off the brake, the same lip on
the wheel must be moved upwards by tapping the upper
side of the lip (2) (See figure 2) .
Option: Swivel wheel left front (Article number: 75560025) .

3.2. Footrest

1
Figure 3 Removing footrest .
Footrest for Reflex (Article number chair:5100 5600) .
• The Reflex footrests can easily be removed from the frame by moving the locking lip
(1) upwards . The footrest is then moved upwards and removed from the frame . Carry
out the same procedure (in reverse order) in order to replace it (See figure 3).
• Before the client takes a seat in the Reflex, the foot plates must be folded upwards .
There is now sufficient room to allow the client to easily take a seat (See figure 4) .
34 | Instructions for use | Reflex Shower-toilet chair
Figure 4 Folding up foot plates .
2
1
Figure 2 Swivel wheel .
Figure 5 Folding down foot plates .