Maintenance And Cleaning; Ordering Spare Parts - EINHELL QH 1800 Mode D'emploi

Anleitung QH 1800_SPK1:_
The quartz radiant heater warms objects or persons
at which it is pointed but does not directly heat the
room air in the process. The heat output is set by a
switch with pull cord. The selected setting is
displayed.
6.1 Setting the heat output (Fig. 1):
The heat output is set by pulling the cord of the pull
switch (3) once or repeatedly. The selected heat
output can be read off the display (2). If the
maximum heat output is selected and the pull switch
is activated once more, the appliance shuts down.
6.2 Display of heat settings
No heat output = Display indicates "0", no heating
elements activated
Minimum heat output = Display indicates "1", one
heating element activated
Medium heat output = Display indicates "2", two
heating elements activated
Maximum heat output = Display indicates "3", three
heating elements activated

7. Maintenance and cleaning

Maintenance and repair work may only be carried
out by an electrical servicing contractor or ISC
GmbH.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or ISC GmbH in
compliance with the relevant regulations.
Important: Disconnect the mains lead before
cleaning – danger of electric shock.
Use a damp cloth to clean the casing.
Never use combustible cleaning agents.
To remove dust on the reflector and heating
elements, use a brush with long soft bristles.
In cases of very stubborn dirt the appliance should
be cleaned by a professional.

8. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part
For our latest prices and information please go to:
www.isc-gmbh.info
24.02.2012 9:56 Uhr Seite 9
GB
9