dirna Bergstrom bycool green line COMPACT 3.0 Instructions De Montage page 21

COMPACT 3.0
OUTSIDE CABIN:
4
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
To place the foam rubber ducting remaining at
5
the softer part of the base.
INSIDE CABIN:
6
Screw about 5 mm (4) 8/125x100 or 120 mm
studs, the exact measure is chosen after the
fastening supports have been presented and
taking into account that studs must stick out of
lower part about 20 mm.
Following this order:
7
- Ø 7 plane rubber wash
- plane ruber wash wide wing diameter 8
- nut M8
- plane washer diameter 8 wide wing
Air conditioning for vehicles
5
Unit base
6
6
plane ruber wash
Ø 7 plane
wide wing Ø 8
rubber wash
7
21
Escotilla
5 mm
Stud
Bracket
20 mm
plane washer Ø8
wide wing
nut M8
EN
4
6