Fitting The Cross Actuation Device - GO2 RH 2 Mode D'emploi

Set the correct distance between tyres and rollers (20 mm) by
moving the drive units (in the disengaged position) in the longi-
tudinal direction. The movable connection pipe makes it pos-
sible to adjust to the frame width.
Figure 25
Move the drive units in a lateral direction in such a way that as
much of the tread area of the tyre as possible is covered.
Ensure that there is an adequate distance between the gear-
box and the tyres / shock absorbers so that they do not come
into contact.
The minimum distance with the drive rollers engaged is
10 mm.
Figure 26
Once the drive units have been correctly positioned, tighten the
bolts (c) of the fastening kit a little, then check the required dis-
tances again. The weight of the caravan must be resting on the
wheels when doing this.
Place the movable connection pipe in the centre (use the mark-
ing) and fix each side with a threaded bolt (g) M8 x 12 (15 Nm).
The threaded bolts are coated with sealant, and must
therefore only be bolted in once.
Re-check the distance of 20 mm from the tyre (with the wheels
under load). Then tighten the 2 bolts of the fastening kit (M10)
several times in turn with a torque of 25 Nm.
Figure 27
The bolts are coated with sealant, and must therefore
only be bolted in once.
20 mm
min. 110 mm
min.
10 mm
25 Nm
RH 2 Manoeuvring Assistant

Fitting the cross actuation device

Make sure that the drive rollers are not engaged on the tyres
(on both sides).
Push the connection pipes (1) into the central pipe (2) with the
holes facing outwards.
Push the connection pipes (1) onto the toggle crank (a). Insert
the bolts (5) through the toggle crank and tighten with the nuts (4)
(10 Nm ± 1 Nm).
Centre the central pipe (2), measuring again if necessary. In
this position, tighten the 2 threaded bolts (3) (15 Nm). Finally,
check all the bolted connections again.
5
1
a 5
4
Figure 28
Engage the rollers using the lever provided. The drive rollers
should now be engaged on both sides. Check the opposite
side as well. Disengage the drive rollers again.
Repeat this procedure on the opposite side.
1
3
2
3
5
4
25