Connecting Cables To Terminals - Kenwood KTC-9090DAB Mode D'emploi

Connecting Cables to Terminals

2CAUTION
DC voltage is output from the DAB
antenna terminal of the DAB
hideaway tuner to supply power to
the DAB antenna. Be sure to connect
the supplied DAB antenna only.
Otherwise, the unit may be
damaged.
DAB connection
cable
(Accessory1)
DAB
K T C – 9 0 9 0 D A B
TO
HEAD UNIT
To control unit
Connection cable
(supplied with the
Disc changer)
Disc changer
■ If you want to connect KCA-S210A
Control unit
]"N"
O
PROTOCOL
SWITCH
KCA-S210A
26
Control unit
DAB hideaway
tuner
HIDEAWAY TUNER
24bit D.R.I.V.E.
TO RDI TO
CHANGER OUTPUT DAB ANTENNA
DAB antenna cable
(Accessory@)
RDI output
KENWOOD disc changer control input
NOTE
To connect the Disc changer, consult your Disc
changer manual.
DAB hideaway tuner
N OFF ON
AUX
AUX
SWITCH
IN
TO TO TO
H/U CHANGER 1 CHANGER 2
To KENWOOD disc changer / DAB control input
P.CONT.
ANT.CONT.
Power control/Motor
antenna control wire
(Blue/White)
1
2
3
NOTE
• To use the data output from the Radio Data
Interface (RDI) connector, a separate RDI-enabled
component is required.
• The Radio Data Interface (RDI) output may contain
test data, but this isn't broadcast data.
Connect the KTC-9090DAB to the
terminal labelled TO CHANGER 2.
TO TO
HEAD UNIT CHANGER
NOTE
Set the PROTOCOL selection
switch to "N" position.
Disc changer
(*...commercially available)
FM/AM antenna input
FM/AM antenna cable*
FM/AM antenna
control cable*
(M10)
DAB/FM/AM
antenna
(Accessory7, 8)