Connecting Wires To Terminals - Kenwood Ez500 Mode D'emploi

Connecting Wires to Terminals

Ez500
A Aux input
B Front output
C Rear output/
Subwoofer output
Left output (White), Right output (Red)
To KENWOOD disc changer/
Sirius satellite radio tuner/
HD Radio tuner/
External optional accessory
To connect these leads, refer to
the relevant instruction manuals.
If no connections are made, do not let the wire come out
from the tab.
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To connect the KENWOOD navigation system,
consult your navigation manual.
To "EXT.AMP.CONT. " terminal of the amplifier having the
external amp control function.
Do not let the wire come out from the tab.
Car fuse box
(Main fuse)
Battery
30
|
English
Fuse (10A)
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
+ –
A
B
P.CONT
Power control/Motor antenna
control wire (Blue/White)
MUTE
Mute wire (Brown)
External amplifier control wire
(Pink / Black)
Dimmer control wire (Orange / White)
ANT.
Not Used
CONT
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse
box
ACC
Ground wire (Black) - (To car chassis)
C
FM/AM antenna input
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)