Installation - Kenwood KTC-9090DAB Mode D'emploi

Installation

■ Mounting the DAB Antenna to the Roof
2WARNING
If a hole to insert the antenna has burrs,
remove them first. Leaving burrs causes
damage to the antenna cable leading to
accidents and failures.
2CAUTION
• Make a hole in the roof and mount the
DAB antenna. Specialized knowledge is
required for this job and an installer should
be requested for the installation work.
• The DAB antenna should be mounted so
that it does not protrude beyond the width
and length of the car.
• Do not install at a spot where the roof is
markedly curved. Doing so will allow
water to enter from a gap between the
roof and the waterproof rubber.
• Securely fasten the screws that fix the
DAB antenna as well as the screws of the
DAB antenna itself. Screws that loosen
introduce the danger of the antenna
coming apart during travel.
1
Determine the mounting position of the
DAB antenna. (It replaces with
established FM / AM antenna.)
2
Wipe away any dirt from the mounting
position.
3
Remove the lining in a place where you
can make a hole in the roof.
Make a Ø19.5 mm round hole, or a
15mm rectangular hole in the roof.
4
Mount the DAB antenna and fasten it
by tightening the nut from the inside.
5
Use a cable clamp to fix the antenna
cable and perform the wiring as far as
the DAB hideaway unit.
100 mm - 200 mm
• In the case of a round fixing hole
DAB antenna
(Accessory7, 8)
Waterproof
rubber
(Accessory9)
Car roof
Nut
(Accessory!)
• In the case of a rectangular fixing
hole
DAB antenna
(Accessory7, 8)
Waterproof
rubber
(Accessory0)
Car roof
Nut
(Accessory!)
Ø19.5 mm
15 mm
27