Placing And Installation; Choosing The Right Place; Connection To Power Supply; Adjusting The Height Of The Appliance - ETNA EEO131VA Mode D'emploi

Placing and Installation

Choosing the Right Place

Place the appliance in dry and regularly ventilated
room. Allowed ambient temperature depends on
the model (class) of the appliance and is stated
on the rating plate of the appliance.
Never place the appliance near heat emitting
devices (e.g. cooker, radiator, water heater or
similar devices) and do not expose it to direct
sunlight.
The appliance should be positioned at least 3 cm
away from the electric or gas cooker and at least
30 cm away from the oil or coal stove. If this is
not possible, use an appropriate insulation.
Class
SN (sub-normal)
N (normal)

Connection to Power Supply

Connect the appliance with the cable and plug to
the power supply socket outlet with a ground
terminal (safety socket).
Required nominal voltage and frequency are
indicated on the rating plate.
The connection to the mains supply and earthing
have to be made according to current standards
and regulations. The appliance resists temporary
voltage tolerance up to -6% to +6 %.
Adjusting the height of the
appliance
The appliance is equipped with four adjustable
legs, so that the height may be adjusted from 82
to 90 cm. The height must be adjusted prior
building the appliance into the opening slot, and it
should be set at such height that the top panel of
the appliance fits exactly below the kitchen
worktop (see Mounting Instructions).
48
Ambient temparature
from + 10°C to + 32°C
from + 16°C to + 32°C
Instructions for Use