Before Putting Into Use; Instructions For Use; Mounting Instructions; We Care For The Environment - ETNA EEO131VA Mode D'emploi

Before Putting Into Use

• Before connecting the appliance to the mains
supply, place it on the location where it will later
on be installed and leave it for about 2 hours,
which will reduce a possibility of malfunctions in
the cooling system due to transport handling.
• Clean the appliance, and be thorough,
especially in the interior (See Cleaning and
Maintenance).
• In case the interior accessories are not
correctly placed, rearrange them as described
in chapter Description of the Appliance.

Instructions for Use

These instructions for use are intended for the
user. They describe the appliance and its correct
and safe use. They were prepared for various
types of refrigerators therefore you might find in it
some functions that do not apply to your
appliance and description of the accesories that
your appliance does not include.

Mounting Instructions

Integrated appliances are equipped with
instructions for mounting the appliance into the
kitchen unit.
The appliance should be mounted by qualified
technician and instructions are for his use only.

We Care for the Environment

• Our products use environmentally friendly
packaging, which can be either recycled or
disposed of in an environmentally friendly
manner. To this end, individual packaging
materials are clearly marked.
• These instructions are printed either on
recycled paper or chlorine free bleached paper.
• When your appliance finally wears out, please
try not to burden the environment with it; call
your nearest authorised service agent. (See
Disposing of the Worn Out Appliance)
46

Tips for Energy Savings

• Try not to open the door too often, especially
when the weather is wet and hot. Once you
open the door, mind to close it as soon as
possible. This is especially important if you
have an upright model.
• Check periodically if the appliance is provided
with sufficient cooling (undisturbed circulation of
air through the bottom rail openings).
• Use higher thermostat settings only when
required or recommended.
• Before loading the appliance with packages of
fresh foods, make sure they are cooled to
ambient temperature.
• Ice and frost layer increase energy
consumption, so do clean the appliance as
soon as the layer is 3-5 mm thick.
• If the gasket is damaged or if it turns out that
the sealing is poor, the energy consumption is
substantially higher. To restore efficiency,
replace the gasket.
• Condenser at the bottom of the appliance must
always be clean and dust free (see Section
Cleaning of the Appliance).
• Always consider instructions stated in sections
Positioning and Energy Saving Tips, otherwise
the energy consumption is substantially higher.
Instructions for Use