Installation And Connection; Selecting The Location - ETNA KVO482 Mode D'emploi

INSTALLATION AND CONNECTION

Selecting the location

• Do not place the appliance near a source of heat, such as a gas cooker, radiator or boiler,
etc., and do not expose it to direct sunlight.
• Place the appliance in a dry and well aired room. The permitted ambient temperature range
for the appliance depends on the appliance's climate class, which is shown on the type
plate.
Description
Extended temperate
Temperate
Subtropical
Tropical
Do not place the appliance in a room where the temperature can fall below the lowest
permitted ambient temperature: the appliance may not work properly!
Do not place the appliance in a room where the temperature can fall below 5 °C: the
appliance may become defective!
The appliance is not suitable for outdoor use and may not be exposed to rain.
Place the appliance in a room with a sufficient volume of air. The room must have a
volume of at least 1 m
shown on the type plate on the inside of the appliance.
• The appliance must be placed at a distance of at least 5 cm from an electrical or gas cooker
and at least 30 cm from a radiator or heater. An insulation panel must be fitted when these
distances cannot be kept.
• The appliance must be placed at a distance of about 5 cm from the wall, back and sides
of a cupboard. A kitchen cupboard above the appliance must have a gap of at least 5 cm
between the back of the cupboard and the wall. This is needed to make sure that there is
sufficient cooling air for the condenser.
• The plug of the installed appliance must remain accessible!
• The kitchen unit in which the appliance is to be built in must have an opening of at least
200 cm in its base to allow sufficient air to circulate.
2
EN 12
Class Ambient temperature range °C
SN +10 to +32
N +16 to +32
ST +16 to +38
T +16 to +43
of air for every 8 grams of refrigerant. The quantity of refrigerant is
3
Relative humidity
≤ 75%