To Start The Product - Zenoah GZ4350 Manuel D'utilisation

Consult your servicing dealer when you select a chain
oil.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Fill the fuel tank and the chain oil tank at the same
time. The capacities of the chain oil tank and fuel
tank are carefully correlated.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and source before starting.
CAUTION: Contamination in the tanks
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.

To start the product

Note: There is a simplified start reminder with
illustrations, that shows you how to start the product, on
the rear edge of the product.
To prepare start with a cold engine
1. Move the front hand guard forward to engage the
chain brake.
320 - 005 - 27.09.2017
WARNING: The chain brake must be
engaged when the chainsaw is started to
decrease the risk that the saw chain
touches you during start.
2. Press the air purge again and again until fuel starts
to fill the bulb. The bulb does not need to be
completely filled up.
3. Set the choke control in the choke position.
To prepare start with a warm engine
1. Move the front hand guard forward to engage the
chain brake.
WARNING: The chain brake must be
engaged when the chainsaw is started to
decrease the risk that the saw chain
touches you during start.
15