To Start The Product - Zenoah GZ3500T Manuel D'utilisation

The chain oil from Zenoah has a vegetable oil base and
is also biodegradable. We recommend you to use of our
chain oil for maximum saw chain life and to minimise
environmental damage. If this chain oil is not available,
we recommend you to use a standard chain oil.
The fuel runs out before the chain oil from the two tanks.
This is a safety feature and it is necessary that you
follow the requirements below:
• Use an oil of the right grade (suitable viscosity
range) to agree with the air temperature. If the oil is
too thin it will run out before the fuel. In temperatures
below 0°C (32°F) some oils become too viscous.
This can cause the oil pump to overload and result in
damage to the oil pump components.
• Adjust the carburetor as recommended. A lean
mixture causes the chain oil tank to empty before the
fuel tank.
• Use the recommended cutting equipment. A guide
bar that is too long will use more chain oil.
WARNING: Do not use waste oil! Waste oil
is dangerous to you and the environment.
Waste oil also causes damage to the oil
pump, the guide bar and the saw chain.
WARNING: Deficiente lubrication of the
cutting equipment can cause the saw chain
to break, which can cause serious injury or
death.
Consult your servicing dealer when you select a chain
oil.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Fill the fuel tank and the chain oil tank at the same
time. The capacities of the chain oil tank and fuel
tank are carefully correlated.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and source before starting.
CAUTION: Contamination in the tanks
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.
308 - 004 - 27.09.2017

To start the product

Note: There is a simplified start reminder with
illustrations, that shows you how to start the product, on
the rear edge of the product.
To prepare start with a cold engine
1. Move the front hand guard forward to engage the
chain brake.
WARNING: The chain brake must be
engaged when the chainsaw is started to
decrease the risk that the saw chain
touches you during start.
2. Press the air purge again and again until fuel starts
to fill the buld. The bulb does not need to be
completely filled up.
3. Set the start/stop switch to the start position.
15